Step By Step Guide For Bathroom Renovations
Bathrooms are one of the important room in the house and they are also one the most expensive to renovate. Bathroom makeover is a job that, if done well, can enhance value to a home and a great space full of design and light.
Bathroom Design
Bathroom renovations are the primary area of your bathroom makeover you need to get right. Just replacing the current bathroom with the same design may not be sufficient. The key to great restroom design is to plan it with the people that are going to keep in mind. However be sure that your bathroom plan also has anover-all use factor as well. For sample: If you were designing a bathroom for families you could still design the bathroom with stress-free access to the bath and bath. This would confirm that the design would also effort for people with limited functionality.
It means if you decide to vend your home or if you are renewing for income your design has a wider market appeal. Excellent bathroom plan also uses the area well, taking into version the light or window space, size of fixtures, and drainage selections. Draw out a plan to scale and precise down the extents of your room. Mark the upcoming drainage points and then and water inlet points. Write down a requirements of the bathroom furnishings to need and want with their sizes. Now marry the two together and see what fits.
Note: Most bathroom drainage and water bay points can be moved but this does come at additional cost.
Bathroom Remodel
If you have plan to do the work by hand or part of the work it is time to employ a skip bin and pull out the old bathroom. If your home was made by experts you may have fibro restroom wall linings with asbestos in it and the best care will need to be taken. You will need some complete body disposable coveralls, eye safety, and quality dust cover. Check with your local structure authority or council concerning the regulation on bathroom asbestos wall coating removal.
Remove everything excluding the plumbing. If you keep the bathroom sanitation in place you will not have to turn the water off for the complete house. Also you will need to jack strike the floor tiles up and the sand and adhesive bed that they are laid on.
Bathroom Makeover and Construction
Bathrooms must be building properly from the ground up to guarantee that the finished job is correct and true. This also confirms the design and look of the bathroom will have the best finish.
The Bathroom Restoration Process
- Install water and drainage pipe and electrical wires.
- Install wall coating and ceiling and then fit the bath hob and bath.
- Water-resistant the floor and bath and bath recess.
- Correct the fall of the ground with sand and cement ready for tiling.
- Lay floor and wall tiles and then grout.
- Install new bathroom vanity, furnishings, and taps – install new electrical.
- Paint ceiling and final clean.
Plumbing and Electrical
At this point all new comprehending is connected for spotless hot and cold water and drainage. Careful attention requirements to be taken when putting the new plumbing so that the plumbing fittings are precise when the roofing is finished. To centre a fitting in a bath recess you must take into consideration the width of the wall boarding, tile glue and tile so the fitting will be focussed after the tiles are in place. The same relates to installing drainage piping for a toilet; the wall lining and tile width must be taken into explanation so the pipe is in the precise position when the toilet is installed after roofing. Also rough in the any new electrical wires without linking them to the mains power.
Install Wall and Ceiling Linings
Install your wall lining being cautious to nail the fibro board each 150mm without tacking into the new pipes and electrical wires. The best way is to amount and mark the tube and wire plan onto your new wall panel with a pencil as you go. Screw up the ceiling lining, plasterboard is the greatest common. However if you are placing your tiles from floor to maximum do not connect the cornice as this is best done afterward tiling. If you are not roofing to the ceiling go ahead and fit the cornice after the wallboard and roofing lining have been fit. Also if your bath is not self-supporting you can now make up the frame and connect the bath. Ensure the bath is fit correctly letting for the thickness of the tiles and glue. Be sure to check all linings and piping before you stay with your bathroom renovation.
Waterproof the Bathroom
Waterproof the bathroom floor, bath area recess, and about the bath. When waterproofing the floor ensure that the waterproofing comes up the walls. The shower break will need to be waterproofed 100mm above the bath rose outlet. Also the bath must be waterproofed 100mm above the lip of the bath right around and to the ground. At the doorway install a 25 x 25mm aluminium angle pasted into place with excellence silicone and water-resistant into the lip. Your complete bathroom should now the tanked, so the all water will only go downcast a drain. Bathroom waterproofing tip: waterproofing is astress-free job but excellence and accuracy is most important.
Tile Floor and Walls
Lay your tiles on the ground first and then mortar. Then lay your wall tiles creation sure that they are level as you lay. Once the restroom tiles have been cut and laid, grout all your tiles and then fit the tiles clean.
Plumbing Fitting and Fixtures
Plumbing services help to install all your plumbing fixtures and taps. Also fitting all your towel rails and soap holders. Fitting your new bathroom pride making sure it is level and closed around the top with silicone and also seal about the bath. Tip: make sure they are at the best place before you drill into the tiles.
Painting, and Cleaning
Paint the ceiling and do a final clean making sure all is fitted correctly and that there are no leaks in your plumbing. – Enjoy your new restroom.